Download click link below
MMS SUBCOURSE NUMBER 151, NIKE MISSILE AND TEST EQUIPMENT
EXERCLSES FOR LESSON 4
1 . What furnishes external power to the guidance set
A. External power supply-8516630
B. RF test set-9143471
C. Electrical test set-9034602
D. AF and power test set
2 . How often does the microsecond oscillator in the
RF test set require calibration?
D. Before each use
3. What furnishes filament voltage for the circuits in
the upper drawer of the RF and pulse components
test set upper drawer?
A. 300-volt power supply
B. t240-volt powei supply
C. -60-volt power supply
D. tl50-volt power supply
4. What type of oscillator circuit is used in the
microsecond oscillator of the transponder control
test set group?
C. One-shot multivibrator
5. What is the main purpose for which electrical test
set 9005609 is used?
A. Calibrate missile test equipment
B. Isolate malfunctions
Confirm accuracy of other test equipment
Measure AC and DC voltage and current
6. Whch voltage does the AC power supply in the
RF and pulse components test set group upper
A. 120 volt, 400 Hertz
B. 120 volts, 1,700 Hertz
C. 120 volts, 200 Hertz
D. -28 volts, 1,700 Hertz
Which is a mode of operation used by the pulse
generator in the lower equipment drawer of the
RF and pulse components test set group?
Which is the attenuation ratio of the AN/USM-
50A test probe?
What produces the positive and negative pitch and
yaw pulses in the RF and pulse components test
A. 0.25-microsecond pulse generator
B. 5-microsecond pulse generator
C. Variable delay pulse generator
D. Variable delay and width pulse generator
What missile test equipment is used to measure the
quality of resonant cavities?
B. Spectrum analyzer
C. RF test set
D. Electrical test set
Which test point on electrical test set 9005609 is
used for a common connection between the source
of voltage to be measured and the test set?
What is the maximum input to the AN/USM-SOA
oscilloscope using the test probe